How to produce a Daybed From a Headboard

Having an attractive cast-off king-size headboard and a no-longer-wanted solid-core interior door, you can gather a comfortable, custom twin-size daybed at a portion of store-bought price. The recycled substances make a sturdy platform which will not slide around but will take some brawn to move. Rev up your carpentry skills and adapt your charity-shop find or curb-bound leavings to generate a one-of-a-kind daybed to your den or guest room.

Remove a king-size wood headboard in the bed frame, wash it and prepare it to the paint and finish conversion you may apply to the entire daybed. Just take the hinges, knob and other hardware off a solid-core wood door. A six-panel door includes a built-in decorative touch to your new daybed frame.

Cut the door in half lengthwise and then cut on one panel at half again horizontally. The very long panel is that the front of the bed platform frame, and both short panels would be the finishes. You won’t require a back panel since the headboard will attach to the side of the platform to become the back.

Trim the panels to fit your precise daybed measurements. A twin bed is 38 inches wide and 75 inches long, and also the long door panel is 80 inches long and 15 inches tall. The panels are 40 inches by 15 inches. The headboard might be up to 82 inches broad; a king bed is 76 inches broad, and a typical headboard is up to 3 inches wider than the bed on every side. A headboard precisely the same width as the length of the long panel is best. Your measurements may vary slightly, so adapt your design into the actual dimensions of the raw materials, keeping in mind that the platform size you will need to your twin bed.

Cut a piece of 3/4-inch plywood to screw to the peak of the door panels to become the bed platform. Distress all the timber by banging and denting it with chains, a hammer, screwdriver and other abrasive and blunt objects before assembly. Skip the distressing should youn’t plan to faux-age the daybed.

Assemble the door panels with the raw — cut — borders uppermost and the finished borders on the ground. Bolt the headboard to the frame with a plate-style headboard bracket in either end to form the long back-side. Insert the bolts to ensure that the nuts and finishes are on the inside, underneath the bed. Drill holes in the door panel frame for wood screws to attach the plywood bed platform to the panels.

Insert right-angle braces to the headboard frame — one on each side — and rest the plywood platform on the braces, screwing the plywood into the braces to secure it to the headboard. Screw the platform into the panels, countersinking the screws.

Sand any rough edges. Prime, paint or whitewash and seal the daybed frame. Allow the frame to dry fully before adding the bed and cushion covers. The platform is approximately 15 inches high and can make a conventional sofa or daybed height when you add the mattress.