The best way to Lube an Clothes Dryer Drum

Clothes dryers are a home equipment that offers a handy way without hanging them on a clothes-line to dry garments. As time passes, the clothes dryer drum starts to squeak or rumble creating sound that is annoying. Stop the sound by lubing the dryer drum with 30-weight oil. The procedure alleviates the expense of employing an equipment repairman and is easy using the proper tools. The dryer has to be tilted, therefore some muscle is needed with this project. Allow approximately 30 minutes to lube the drum of a clothes dryer.

Unplug the clothes dryer.

Remove the filter.

Remove the panel in the clothes dryer. Pull the dryer from the wall around 12-inches. So the bottom is uncovered tilt the dryer backward. Locate the two to four screws immediately below the front-panel. Remove the screws to produce the bottom of the front-panel. Pull the panel from the dryer. Two clips that are leading support the the panel in position. Slide a putty knife in the clips in the event the panel doesn’t come off easily and pry them open to free the panel.

Locate the motor on the correct side of the drum of the dryer. Locate the belt connected to the motor. Until a little wheel is positioned look or sense over the belt. The little wheel is connected to your shaft. Squeeze 2-3 drops of 30-weight oil on one in the top, every bearing and one in the base of the shaft.

Rotate the drum yourself. Listen to produce sure no sounds are emitted. Add more oil if required.

Locate a little spring just over the belt by the motor. Lift the shoot up up to eliminate the belt in the wheel. Remove the belt in the wheel.

Place your knee underneath the drum. Lift and slide the drum-off a corner rollers and take it off in the dryer casing.

Locate the rubber-rimmed rollers with roller bearings in the rear of the casing that was drying. Squeeze 2-3 drops of oil on again and the entrance of every roller bearing.

Lift the dryer drum and spot it straight back on the rubber- rollers. Hold the drum by means of your knee. Lift the spring over the motor and place the belt in its correct location.

Slide the top-front of the dryer panel to the clips. Press the bottom of the panel in place and safe.

Tilt the dryer again on its toes. Slide the clothes dryer in spot and plug it in.

Throw a damp fabric in the dryer drum. Run a brief cycle to find out if all noises are eliminated. If maybe not, t-AKE oil the shaft a second-time and the panel off.