13 Steps To Buy, Install And Finish Your Drywall

The walls within your home give you some feeling of security. You spend almost your entire life inside the palisade created by walls. When it comes to interiors, walls are decorated to enhance their aesthetic appeal. Also, you can use your walls by hanging your favorite artworks and your family portraits. If you are planning to refurbish your living space, you should not forget your walls. Once you get started, the first thing you have to consider is the installation of your handyman Tuscaloosa.

A drywall comes in lots of sizes from 4×8 and 4×10 to 4×12. When it comes to its installation, the technique that most experts use is with long sides from the floor running to the roof. There are instances wherein it’s perfectly fine to place a drywall horizontally as it can save a couple of joints.

In some cases, you’ll be able to get drywall sheets at your nearest building material store. They come in widths of 10 feet to 12 feet. As for the thickness of the sheets, they are ½ inch each for walls. For ceilings, they come at 5/8 inch each. Before you make your purchase, we suggest you check your local building codes.

Now that you know more about the is, let’s proceed to the 13 easy steps of installing a .

Step 1: Ask the assistance of a friend for this step. Together, lift a drywall sheet against your ceiling. Then, hold it across your framing with the use of a T-brace that’s built at least ¾ inches shorter than the height of the floor to the ceiling.

Step 2: To cut a drywall sheet, you’ll need a drywall square as it will guide you while you use the utility knife to score across the face of the panel.

Step 3: After you have snapped score line, nick the front’s backing paper. After that, score from the back.

Step 4: Lift your drywall sheet so it’s at the top of your wall. Then, set it by nailing it in place.

Step 5: Install steel protection plates (self-gripping). Just hammer them into the studs.

Step 6: Using your drywall square, transfer measurements onto the panel. Then, cut outside the lines that you drew with your pencil using a drywall saw.

Step 7: Nail your drywall into the stud.

Step 8: Check if the bead is aligned properly when you view it from both sides. Then, nail one of the faces completely before you nail the second side.

Step 9: Spread compound on the surfaces. Fold a piece of paper drywall tape at the center. Then, press it towards the corner.

Step 10: Using your inside corner knife, squeegee the excess compound.

Step 11: Press paper tape to the joint and wipe out the excess.

Step 12: Apply another coat of compound. Once it’s dry, sand lightly using a sanding sponge.

Last step: Apply 2 more coats right on top using a 6-inch knife and voila! You’re done!