The way to repair the Eureka Vacuum 4870 Series

The Eureka 4870 Series vacuum is a vertical model which comes equipped with features including an upholstery nozzle, a crevice tool and a headlight to make cleaning the surfaces in your home easier. While the vacuum comes with a two-year limited warranty if it’s used in accordance with the operating instructions, you may encounter problems that prevent it from working correctly. Some problems are common, like failing to flip on or giving off a strange smell. You may have the ability to fix the problem yourself without calling Eureka or a trained service technician.

Power Outage

If your battery’s motor won’t start, it may have a very simple power problem, such as its power cord not being plugged in or a problem with your home’s fuse box or circuit breaker. However, your vacuum may stop or fail to start if its thermal cutoff has activated. The thermal cutoff helps protect the vacuum at the event the motor overheats by closing off when the thermostat senses Debate. To get the appliance working, turn the power switch off and unplug it. Inspect the vacuum for problems that may cause overheating, like a clogged hose, clogged filter or even complete dust cup. Fix the problem and allow the vacuum to sit down for at least 30 minutes before plugging it back in and turning it on. If the motor still won’t start, call Eureka to get aid.

Dirty Floors

If your vacuum won’t pick up dirt on carpeting or a bare floor, there can be a problem with its dust bag or filters. Check the dust bag to see if the debris has reached the fill line, and remove the bag and put in a brand new one if needed. Remove the motor filter; if it’s less than a few months old, then clean it and reassemble it. At three months, then replace the filter. Replace the HEPA filter every six months. The vacuum may fail to wash if its belt is cracked or worn. To replace the belt, move the brush roll control to the bottom setting and hold it firmly until it locks. Lower the handle flat onto the floor using the handle release, and flip the vacuum above. You’ll need to remove the three screws on the base plate so you’re able to get the brush roll and get rid of the old belt. Seat the belt around the motor shaft and brush roller, and reassemble by placing the left end of the roll initially. Your new belt may seem to fit loosely, but that is normal. Use your hand to rotate it 2 times into the center belt. Replace the base plate and screw it back into place.

Hose Issues

If your vacuum does not have any suction in the end of its hose, then make sure the knob selector is placed on the hose functional setting. Then check to see whether there’s an problem with the dust bag or filters. Replace them if required as outlined above. The hose may have inferior suction if you will find clogs from the hose or tubes which are impeding airflow. To check the hose to get a clog, remove the hose end and flex the hose to loosen any trapped debris. For those tubes, turn the twist lock into the unlocked position utilizing a coin, and lift the tube latch. Gently pull the small tube down and away from the vacuum. To detach the tubing from the hose, then twist gently. Repeat the exact same procedure with the large tube. Check both for blockages and flex to eliminate. Rinse the tubes using warm water and mild dish detergent, and allow them to dry completely before reassembling.

Burn Out

If you notice a burning smell when you use your vacuum, a problem may exist with the brush or belt roll. Analyze the belt to see if it’s worn or damaged, and replace it if needed. Check the belt roll for debris that might be preventing it from spinning correctly. Use scissors to carefully cut any hair, fibers or threads that might be stuck across the roll. Analyze the roll for debris once a month to prevent future problems.